Instruction manual

5. Application Operation
5-76
RF-20A/20Axs
5.7 Connecting to an SCL-10Avp System
Controller
5.7.1 Setting the Instrument
To operate this instrument with an SCL-10Avp system controller, make the following settings.
∗ The instrument operates while recognized as an RF-10AXL.
5.7.2 Basic Parameters
The following settings and operations are possible from an SCL-10Avp. For details, refer to the SCL-10Avp
instruction manual.
• Wavelength setting (single wavelength mode only)
• Lamp ON/OFF status
• Gain setting
• Sensitivity setting
• Setting the output range to the recorder
• Response setting
• Setting the spectrum measurement parameters and executing measurement
• Time program creation
Setting Screen Set Value Page
LOCAL 0: Remote ^ "Setting the Local Mode [LOCAL]" P.5-29
ADRS Remote control address ^ "Setting a Remote Control Address [LINK ADRS]" P.5-29
OP MODE 1: XL
∗
^ "Selecting the Operation Mode [OP MODE]" P.5-46