Instruction manual

5.7 Connecting to an SCL-10Avp System Controller

5-77

RF-20A/20Axs

5.7.3 Notes on Operation

 Restrictions in the RF-10AXL Compatibility Mode

When this instrument is used while connected to an SCL-10Avp, it operates as an RF-10AXL and the

functions are therefore restricted in the following way.

• The dual wavelength mode cannot be used.

• The EVENT2 terminal in the external input/output terminals cannot be used.

• The temperature of the flow cell cannot be set from the SCL-10Avp. Set the temperature at the instrument

itself.

^ "Setting the Flow Cell Temperature [CELL TEMP] (RF-20Axs Only)" P.5-17

• The settings of analog output connectors 1 and 2 ([ANALOG1 MODE], [ANALOG2 MODE]) are fixed as

follows.

^ "Setting the Output Mode for Analog Output Connector 1 [ANALOG1 MODE]" P.5-20

"Setting the Output Mode for Analog Output Connector 2 [ANALOG2 MODE]" P.5-21

• The setting range for the response is as follows.

^ "Setting the Response [RESPONSE]" P.5-18

• The setting ranges of the commands that can be used in time programs are restricted.

^ "5.4.1 List of Commands That Can Be Used in Time Programs" P.5-54

Connector Set Value Output Mode

Analog output connector 1 0 INTEGRATOR (Connect a Chromatopac or a variable range recorder.)

Analog output connector 2 1 RECORDER (Connect a fixed range recorder.)

Set Value Time Constant (Units: sec)

10.1

20.5

31.5

43.0