Instruction manual
9.1 Installation
9-9
RF-20A/20Axs
9
Cutting SUS tubing:
1
Position the provided file (for cutting SUS tubing,
Part No.: 670-18928-02) diagonally against the
tubing, and make an even incision around the
whole circumference of the tubing.
∗ Make the incision in the tubing so that it is at
right angles to the tubing's axis.
Fig. 9.8
2
Holding the tubing at equal distances from the line
of the incision, bend it up and down and from side
to side to cut it off.
3
File the cut surface to make it smooth and straight.
Fig. 9.9
Cutting resin tubing:
Cut off the resin tubing at right angles using a cutter.
Fig. 9.10
SUS tubing
Resin tubing
Cut at right angles