Instruction manual
9.1 Installation
9-27
RF-20A/20Axs
9
9.1.8 Wiring
Connectors
Use those connectors among the above that are needed for the system. Connection instructions are provided
on the following pages.
Fig. 9.41
!WARNING
• Before performing wiring, turn OFF all the components and unplug the power cords.
• Do not use cables other than those specified for wiring.
• Do not perform any wiring operations other than those indicated.
Failure to observe these points will cause fire, electric shock or equipment failure.
• [REMOTE] connector: For connection to the system controller.
• Analog output connectors 1 and 2: For connection to Chromatopac (or other integrator) or recorder
(switched by the setting).
• External input/output terminals: For connection to the external equipment.
^ "Connection to External Input/Output Terminals" P.5-81
[REMOTE] connector: P.9-30
Analog output connector 1:
P.9-31 and P.9-32
External input/output
terminal: P.5-81
Analog output connector 2:
P. 9 - 31 and P.9-32