Instruction manual

4. Basic Operation
4-22
RF-20A/20Axs
4
Press repeatedly until [λ MODE] is
displayed.
5
Enter and press .
This sets the measurement mode to dual
wavelength.
Initial screen in the dual wavelength mode
6
Press twice.
Setting of the measurement mode ends and you
are returned to the initial screen.
NOTE
On pressing on the keypad, the indication
changes between channel 1 and channel 2.
4.2.2 Setting the Measurement Wavelengths
Set the excitation wavelength and emission wavelength for each channel.
The setting ranges for the wavelengths are as follows. These ranges are common to channel 1 and channel 2.
NOTE
In the dual wavelength mode, neither channel 1 nor channel 2 can be set to 0 nm.
1
Press .
The initial screen will be displayed.
MOD E1
1:Single 2:Dual
EX200nm EM300nm
Xe:ch1 10 00.00
The channel whose information is
currently displayed is shown here.
Wavelength Setting Range (Units: nm)
EX (excitation wavelength) 200 to 900
EM (emission wavelength) 200 to 900
EX200nm EM300nm
Xe:ch1 10 00.00