User's Manual

(1) Determine the installation
position for the bracket,
and then attach the aero
bar protective sticker.
(2) Install the bracket to the
handlebar as shown in the
illustration. Tighten the cable tie along the groove in the adapter.
Tighten the cable tie along the groove in the adapter.
1514
(6) Repeat steps (3) and (4) for each unit until all units have been paired.
(7) Once pairing has been completed for all units, press the set button
(exit▼) to exit the pairing operation.
* If multiple SC-7900 users carry out pairing simultaneously, the units
for other users may become paired with your own system.
In order to make sure that pairing is carried out correctly, do not
carry out pairing near any other users who are also carrying out
pairing, or near any other devices which may operate wirelessly.
* After pairing has been completed, each user should check to make
sure that pairing has been carried out correctly.
* The st-R and st-L (ST wireless units) are optional.
* The ST wireless units will start operating once bot the left and right
units have finished being paired. They will not operate only by
themselves.
(SM-EW79F-E/I) (SM-SC79)
(5) When pairing is complete, “ ™ ”wil appear beside the name of the unit
which has just been paired. If you press the
select button, the main unit will switch to
pairing standby mode. You can then continue
to carry out pairing operations for any other
unit which has not yet been paired.
* Do not press the set button (exit▼) until
pairing has been completed for all units.
< SM-SC79, SM-EW79F-E/I >
(1) Install the bracket band to the middle of the
bicycle handlebars. Tighten the band using the
fixing bolt.
Handlebar installation diameter :
31.8 mm / 25.8 mm (using an adapter)
Tightening torque : 1.5 N·m {13 in.lbs}
(2) Install the bracket to the band.
Tightening torque = 1.0 N·m {8 in.lbs}
■ Installing the bracket
■ Installing the bracket to the aero bar
6. Installation
CAUTION:
Carry out pairing for a unit before installing the unit.
(For details on pairing, refer to page 13.)
< SM-EW79F-I >
(1) Before installing the main unit, switch it to setting mode and set the
user details and any other necessary settings.
(For details on starting up setting mode and methods of operation,
refer to page 26.)
(2) Slide the main unit into the bracket
as shown in the illustration to install
it. At this time, insert the main unit
securely until it clicks into place.
■ Installing the main unit
Aero bar protective sticker
* For the SM-EW79F-I, replace the adapter and
band to match the handlebars being used if
required.
Tightening torque = 1.0 N·m {8 in.lbs}
(For details on connecting the cables, refer to page 00.)
Adapter 12 mm
18 mm
15 mm