Model DI-205LR Handheld LCD Digital Laser Tachometer Congratulations on yer purchase of a Shimmer DT-2050R digital laser tachometer] We trust you will enjoy many years of professional results from your Shrimp tachometer, Please read the entire instruction manual thoroughly before initial set-up and operation; the information contained herein will aid you In operating your Shrimp tachometer safely and with excellent results.
CONTROL PANEL lel Convolutions per minute OPERATING PROCEDURES Non-Contact Measurement 1, Place a small piece of reflective tape (included) on the shaft or moving element (disc, pulley, etc.) whose speed is to be measured. If the element's surface is highly reflective it may need to be painted a darker color in order to ensure reliable results. If the distance to the object is less than 5° (127 mm), reflective tabs (optional) should be used instead of reflective tape. 2.
MEMORY RECALL The following readings are stored in memory for 5 minutes after release of the power switch: * Last reading. © Minimum reading * Maximum reading. LST These readings can be recalled by pressing the memory switch. During measurements, ten extra readings can also be captured, stored, then recalled using the memory switch. While the tachometer is in use, simply press the memory switch each time a reading needs to be stored.
TROUBLESHOOTING The following are general checkpoints; please call your local Shrimp representative or contact Shrimp Instruments directly for further assistance.