User Manual

2-26
configurations following all description of 3.2.1 BarCode Setting.
3. Run the WordPad software program.
4. Press one of the three barcode reader trigger buttons.
5. Aim the scanning beam at the center of barcode.
6. Good scanning position.
The reading range is from 40 to 300mm distance.
1) Decrease the scanning distance to the bar code when scanning small
barcodes.
2) Increase the scanning distance from the bar code when scanning large
barcodes
3) The scanning area is visible by a red laser beam.
7. Bad scanning position.
1) Make sure that the laser beam sweeps across whole bar code.
2) Scanning operations may fail if the laser beam is positioned as below.
8. upon reading a barcode, the red LED indicator turns on until the trigger is
release or after five seconds. The green LED and the beep tone indicates a
good read.
Note: This product scans using laser light. Never look directly into the laser light or
shine the laser light into the eyes.
2.5.8 Help
To tap “?” can get help information for each program.