User Manual

2-27
2.6 Power management
2.6.1 Suspend Mode
The PDT will go into a suspend mode when it
is idle for a period of time. The idle duration
can be customized using the Power control
panel (refer to Figure “Schemes Tab”)
Suspend mode works and looks just like you
have turned the unit off. Press the key to
suspend the PDT, Press the key again for
the PDT to resume its Previous state.
Use the Battery power control panel to set
the duration to switch state to Suspend mode
when system using battery power. This will
save battery power when PDT is not in use.
Figure 2-24 Schemes Tab
Suspending:
The following conditions will suspend:
z Press <Power> key while the unit is on.
z
The duration timer of item “Switch state to Suspend” expires, which indicates
that there has been no use for a specified of time.
z
The battery pack is completely discharged.
z
Tap Start > Suspend
Tap here to let PDT enter into
suspend mode