User's Manual

2-7 / 121
2.4.2 Power on / off
¾ To turn on the Device
Press the Power key briefly ( ). If the Device does not power on, perform
the cold reset. See chapter 2.7.2.
As the Device initializes its file system, it splash screen displays for about 30
seconds followed by calibration screen. Every time you perform a cold reset,
these screens will also appear.
To turn off the Device, just press the Power key again. This action does not
actually turn off the Device, it only turns the Device into suspend mode. All
running applications remain as you left them, until you press the Power key again
to resume operation of the Device.
2.4.3 Calibration of the touch Screen
On the initial boot-up of the Device, the
stylus calibration screen (Labeled Align
Screen)opens. Use the stylus to press and
hold briefly on the center of each target as
it moves around the screen.
If necessary, adjust the backlight on the
Device to make the screen readable.
When you feel the touch screen function
is poor or the operation does not match
the exact location it should be, please
recalibrate the screen by using the stylus
to tap the Start > Settings >
Control Panel > Stylus, to open the Figure 2-9 Calibration
“Calibration” to recalibrate again.