User's Manual

▶

Initializing the Mobile Device back to the factory default settings

(Hard Reset)

There are many possible reasons why the Mobile Device has to be

reinitialize back to the factory default setting, like, when the device would

not respond even after performing a reset or the user forgets the password

set on the system. This process is called “Hard Reset.” When performing

hard reset, all information in the RAM (files, system settings, installed

programs) will be cleared.

To insure the safety/integrity of the information, make a backup or make a

copy of it in the SD card before performing a hard reset. Restore the

information after the hard reset process to recover the information.

As said earlier, all information stored in the Mobile Device’s RAM will be

cleared after performing a hard reset. However, it is possible to recover

information backed up to the PC, SD card or the Web folder

To perform a Hard Reset:

1. Remove the Mobile Device form the cradle.

2. Perform the following depending on the power state of the device:

• When the device is powered on, while holding down the [1]-[#]

buttons, poke the reset key using the Stylus pen.

• When the device is powered off, while holding down the [1]-[#]

buttons, press the [power on] button.

3. Wait until the Mobile Device re-starts.

Initialize to factory default

VIII-2