User's Manual
Table Of Contents
- STM-7100 User Manual_SHC_rev.01
- ActiveSync 28T------------------------------------------------------------------------------------------------------- 45
- Reset 28T-------------------------------------------------------------------------------------------------------------- 46
- Fundamental Problems 28T--------------------------------------------------------------------------------------- 46
- Appendix A. Additional Information28T------------------------------------------------------------------------- 49
- Usage and maintenance 28T------------------------------------------------------------------------------------- 49
- Device Handling 28T------------------------------------------------------------------------------------------------ 49
- Specification28T------------------------------------------------------------------------------------------------------ 50
- When you turn on the unit, basic screen will be displayed.
- Functions of Icons in the basic screen are explained as bellows.
- You need to install the ActiveSync program for connecting this unit to the Computers.
- Please refer the “Connect to the PC” pages for installation and how to use of ActiveSync.
- From the Start menu, run Internet Connector to connect with network through WLAN. Then you can use internet explorer to browse the internet.
- You can turn On/Off the WLAN
- 1) Backup/ Restore files with ActiveSync
- 2) Program installation with ActiveSync
- Memory
- You can use two kinds of memory for IMP-600(Built-in RAM and Micro SD Card).
- ActiveSync 28T------------------------------------------------------------ 45
- Reset 28T----------------------------------------- 46
- Fundamental Problems 28T-------------------------------------------------------- 46
- Appendix A. Additional Information28T------------------------------------------------ 49
- Usage and maintenance 28T------------------------------------------------------ 49
- Additional information
- FCC warning-15c
④ ActiveSync installation is finished. Please turn on and put the STM7100 unit to the cradle with
USB cable connected to the PC. We will start the drive installation.
▶ Driver Installation
① After you connect this unit to the PC, Select List or specific location installation and click Next on the
New H/W explorer Wizard.
② Select “ Search for the best driver in these location” and check the “Include this location in the search”
and click Next
- 19 -