User's Manual
Table Of Contents
- STM-7100 User Manual_SHC_rev.01
- ActiveSync 28T------------------------------------------------------------------------------------------------------- 45
- Reset 28T-------------------------------------------------------------------------------------------------------------- 46
- Fundamental Problems 28T--------------------------------------------------------------------------------------- 46
- Appendix A. Additional Information28T------------------------------------------------------------------------- 49
- Usage and maintenance 28T------------------------------------------------------------------------------------- 49
- Device Handling 28T------------------------------------------------------------------------------------------------ 49
- Specification28T------------------------------------------------------------------------------------------------------ 50
- When you turn on the unit, basic screen will be displayed.
- Functions of Icons in the basic screen are explained as bellows.
- You need to install the ActiveSync program for connecting this unit to the Computers.
- Please refer the “Connect to the PC” pages for installation and how to use of ActiveSync.
- From the Start menu, run Internet Connector to connect with network through WLAN. Then you can use internet explorer to browse the internet.
- You can turn On/Off the WLAN
- 1) Backup/ Restore files with ActiveSync
- 2) Program installation with ActiveSync
- Memory
- You can use two kinds of memory for IMP-600(Built-in RAM and Micro SD Card).
- ActiveSync 28T------------------------------------------------------------ 45
- Reset 28T----------------------------------------- 46
- Fundamental Problems 28T-------------------------------------------------------- 46
- Appendix A. Additional Information28T------------------------------------------------ 49
- Usage and maintenance 28T------------------------------------------------------ 49
- Additional information
- FCC warning-15c
the default setting.
Fundamental Problems
Q1. The power button is pressed but the power does not turn on
The built-in battery is exhausted. Please charge the battery
Q2. Even if the built-in battery is completely charged, it discharges after a short period of time.
Set the power management
start > setting > display > lighting
start > setting > brightness
start > setting > power > battery (set idling condition)
For more detail, see chapter 8 ‘Device setting and optimizing’
Q3. The power was suddenly cut off
The built-in battery is exhausted. Please charge the battery.
If not, automatic suspend is active. Set the power management (start > setting > system > power)
For more detail, see chapter 8 ‘Device setting and optimizing’
Q4. The screen was tapped, but no correct action was executed.
Touch screen adjustment is incorrect.
Adjust the touch screen (start > setting > system > screen)
For more detail, see chapter 8 ‘Device setting and optimizing’
- 47 -