User's Manual
Table Of Contents
- STM-7100 User Manual_SHC_rev.01
- ActiveSync 28T------------------------------------------------------------------------------------------------------- 45
- Reset 28T-------------------------------------------------------------------------------------------------------------- 46
- Fundamental Problems 28T--------------------------------------------------------------------------------------- 46
- Appendix A. Additional Information28T------------------------------------------------------------------------- 49
- Usage and maintenance 28T------------------------------------------------------------------------------------- 49
- Device Handling 28T------------------------------------------------------------------------------------------------ 49
- Specification28T------------------------------------------------------------------------------------------------------ 50
- When you turn on the unit, basic screen will be displayed.
- Functions of Icons in the basic screen are explained as bellows.
- You need to install the ActiveSync program for connecting this unit to the Computers.
- Please refer the “Connect to the PC” pages for installation and how to use of ActiveSync.
- From the Start menu, run Internet Connector to connect with network through WLAN. Then you can use internet explorer to browse the internet.
- You can turn On/Off the WLAN
- 1) Backup/ Restore files with ActiveSync
- 2) Program installation with ActiveSync
- Memory
- You can use two kinds of memory for IMP-600(Built-in RAM and Micro SD Card).
- ActiveSync 28T------------------------------------------------------------ 45
- Reset 28T----------------------------------------- 46
- Fundamental Problems 28T-------------------------------------------------------- 46
- Appendix A. Additional Information28T------------------------------------------------ 49
- Usage and maintenance 28T------------------------------------------------------ 49
- Additional information
- FCC warning-15c
Body-worn Operation
This device was tested for typical body-worn operations with the back of the device kept 0 cm
between the user’s body and the back of the device.
To comply with FCC RF exposure requirements, a minimum separation distance of 0 cm must be
maintained between the user’s body and the back of the device.
Third-party belt-clips, holsters, and similar accessories containing metallic components may not be
used. Body–worn accessories that cannot maintain 0 cm separation distance between the user’s
body and the back of the device, and have not been tested for typical body-worn operations may
not comply with FCC RF exposure limits and should be avoided.