Manual of dehumidifier Model No.
CONTENTS SAFETY INSTRUCTIONS 2 QUICK VISUAL SAFETY GUIDE 4 FEATURES 4 INSTALLATION 5 POSITIONING THE DEHUMIDIFIER 5 PARTS 6 CONTROL PANEL 7 WATER DRAINAGE 9 CARE AND MAINTENANCE 10 TROUBLESHOOTING 11 TECHNICAL DATA 12 WARRANTY 13 1
SAFETY INSTRUCTIONS IMPORTANT • • • • • • • • • • • • • • • • • • • • • Carefully read the instructions before operating the unit. This appliance is for indoor use only and intended for use in a domestic environment only. Any other use is not recommended by the manufacturer and may cause fire, electrical shocks or other injury to user or property. If you are in any doubt about the suitability of your electrical supply, have it checked and if necessary, modified by a qualified electrician.
• • • • • • • • • • • • Before moving the appliance,the water tank should be emptied. The handle on the appliance is designed to aid in its movement and should not be used to support the full weight of the dehumidifier. When carrying the unit, it should be kept upright and sufficiently supported from its base. The appliance must be placed in a room without sources of ignition (for example: open flames, an operating gas appliance or an operating electric heater).
QUICK VISUAL SAFETY GUIDE ON WHERE OR WHEN NOT TO USE YOUR DEHUMIDIFIER FEATURES 1. Easy to use controls. 2. Easy to carry around handle. 3. Great for up to 3 bed houses. 4. Cost effective way to combat mould, condensation and damp. 5. Laundry mode - dries laundry more efficiently than a tumble dryer. 6. Designed to complement any modern space. 7. Intelligent CPU controlled digital humidistat with 30-80% RH and room humidity display. 8. 24 hours start / stop timer. 9.
INSTALLATION Remove any water from within the water tank before starting the unit. In order to save energy,do not open windows or doors while the unit is running. Place the unit on a hard / flat surface. On first use, run the unit continuously for 24 hrs. TO REDUCE NOISE LEVELS: Place a piece of carpet or a rubber mat under the unit to reduce any vibrations while the unit is running. Our dehumidifier uses compressor technology to extract water from the environment.
PARTS HANDLE FILTER FRAME ACTIVATED CARBON FILTER DRAIN PORT CONTROL PANEL POWER CORD STORAGE WATER TANK OPTIONAL Activated carbon filter (Optional) The replacement time of the activated carbon filter depends on the frequency and location of your use. It is recommended to replace it every six months, not more than one year at most. and replacement needs to be purchased by yourself. Please search our official website of Shinco (www.shincoglobal.com) to purchase it.
CONTROL PANEL POWER Turn the appliance on/off MODE Select the operating mode of the unit between Laundry and Auto. The fan will operate continuously to monitor the humidity. AUTO MODE: The unit will start dehumidifying when the humidity increases to 5% above the desired humidity and will stop when the humidity drops to 5% below the desired humidity.
NOTES • If a permanent drainage pipe is fitted,the unit will not stop operating. Setting the desired humidity to around 35% is good for laundry mode, a quick drying boost, or in emergencies. It is not recommended for long normal operation in a domestic or office environment. To allow more moisture in the air, set a higher desired humidity (e.g. 60%-70%). We recommend setting the desired humidity to 50-55%. This is great for domestic operation and dry storage.
WATER DRAINAGE When the water tank is full, the unit will stop automatically. When this happens,the TANK FULL light will show on the control panel. NOTE: Only empty the water tank when it is full or before moving or storing the unit. There are two ways to dispense collected water. USE THE TANK When the tank is full, the unit will automatically stop running, and the Tank Full indicator will illuminate. Slowly pull out the tank. Grip the tank by its handle securely, and carefully pull it out.
CARE AND MAINTENANCE Always shut off the unit and unplug from the mains before cleaning or performing any maintenance. When it is not in use for long periods,it is advisable to remove the plug from the power socket. Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage to the unit. 1. CLEAN THE GRILLE AND CASE Use water and a mild detergent to clean the washable filter frame. Do not use bleach or abrasives.
FREQUENTLY ASKED QUESTIONS Why doesn’t the dehumidifier seem to extract much water if the temperature is low? This is a compressor dehumidifier which works best in temperatures above 59℉ (15⁰C). If the temperature is low and the air is dryer than the setting on the humidistat,the unit will not extract water. If you want to use a dehumidifier for outside buildings, unheated properties, boats or garages,pls check our desiccant range.
TECHNICAL DATA Model SDL-30P Color white Power supply 110~120V/60Hz Power input (w) 280 Rated current(A) 3 Specification Moisture Removal (90°F,RH90%) Water tank capacity(Water full)(Liter) Refrigerant Features 1.5L R134a Noise level (dbA) Type 30 42 Mechanical/Electronic Electronic Timer 24H Display LED water-full alarm YES cloth-dry function YES Continuous drianage function YES Frost prevention YES Net/Gross Weight (Kg) 9.5/10.
Warranty TO OBTAIN WARRANTY SERVICE: Please contact us by email. Sales support: service@shinco.net WARRANTY PERIOD: Labor: 1 Year from the Date of Purchase. Parts: 1 Year from the Date of Purchase. SHINCO Electric Co., Ltd reserves rights to upgrade products without user notice.