Operator`s manual

1. Turn the unit over so that the gear case output shaft faces UP.

2. Lock gear case by inserting a 4mm hex wrench (DD) into locking hole. Ap-

ply light pushing force to wrench while turning splined power output shaft.

Continue turning until wrench engages locking notch on underside of blade

xture (T). Hold wrench securely to prevent output shaft from turning.

3. Turn trimmer head (FF) clockwise to remove.

4. Remove spacer (GG). Remove wrench.

5. Place blade (EE) over mounting arbor on upper blade xture (T). Install clip

(W) in shaft groove to retain blade. Place lower blade holder (X) on output

shaft (HH), covering clip. Holder must t at against blade and completely

cover clip.

6. Install bolt guard (Y) on the output shaft.

7. Install the 7x26 mm blade retaining bolt with at washer (Z). Using the

combination spark plug wrench/screwdriver, tighten the bolt rmly in a

counterclockwise direction.

8. Remove hex wrench.

Install Brushcutter Blade

The unit should now be completely assembled

and ready for use with a blade.

IMPORTANT!

Units with adjustable carburetors must be readjusted for blade use, otherwise

serious engine damage can occur.

Gear Case #4 with side-mounted locking tool hole, grooved

output shaft, and gear case cover: