Operator`s manual

26107

IMPORTANT!

Units with adjustable carburetors must be readjusted for blade use, otherwise

serious engine damage can occur.

Install Brushcutter Blade

1. Turn the unit over so that the gear case output shaft faces UP.

2. Align the hole in the holder (GG) with the notch in the gearcase ange,

and then temporarily lock the output shaft by inserting a hex wrench (DD)

through both holes.

3. While holding the hex wrench, turn the trimmer head (FF) clockwise to

remove. Remove the hex wrench.

4. Remove trimmer head holder.

5. Install large upper blade holder (O) onto output shaft (HH).

6. Align the hole in the upper blade holder with the matching notch in the gear

case ange, and then temporarily lock the output shaft by inserting a hex

wrench through both holes. Hold hex wrench in place until blade retaining

bolt is tightened.

7. Fit the blade (EE) over the ange on holder (O).

8. Install large lower blade holder (P) on the output shaft.

9. Install the bolt guard (Q) and then the 7x20 mm blade retaining bolt with

lockwasher (R). Using the combination spark plug wrench/screwdriver

(BB), tighten the bolt rmly in a counter-clockwise direction.

10.Remove hex wrench.

NOTE:

There are four gear case congurations. Select one of the following instruc-

tions to properly install a metal blade.

The unit should now be completely assembled

and ready for use with a blade.

Gear Case #1 with notched ange: