Operator`s manual

11
1031
WARNING!
Never operate the F220 with a saw
blade. This may result in serious injury.
NOTE:
Consult with your Shindaiwa dealer for neces-
sary items for blade-use. (T220)
NOTE:
The collar and the holder for trimmer head
use, are not to be used. (T220)
1. Turn the brushcutter upside down so
the gearcase output shaft is facing UP.
Align the hole in blade holder A with the
matching hole in the gearcase flange
and temporarily lock the output shaft by
inserting a hex wrench through both
holes.
2. Using the spark plug wrench, remove
the arbor bolt, bolt guard and holder B
from the gearcase shaft.
C220/T220 Cutting Attachment Installation and Assembly
3. Next, slide the safety clip off-center.
IMPORTANT!
Install the blade so its printed surface is
visible to the operator when the brush-
cutter is in the normal operating position.
4. Fit the blade over the safety clip and then
center it over the flange on holder A.
5. Lock the blade in place by centering the
safety clip on the output shaft.
6. Install blade holder B on the output
shaft. The recess in the holder must
completely cover the safety clip and
must fit tightly against the blade.
7. Install the bolt guard and then the blade
retaining bolt. Using the spark plug
wrench, tighten the bolt firmly in a coun-
ter-clockwise direction.
8. Remove the hex wrench.
WARNING!
The blade must t at against the
holder ange. The blade mounting hole
must be centered over the raised boss
on blade holder A.
WARNING!
Never operate the brushcutter without
the safety clip in place!
Mounting a Blade C220/T220
1. Make sure the switch is off and the
engine is stopped.
2. Wear gloves to protect your hands.
Arbor Bolt
Bolt Guard
Output
Shaft
Holder B
Slide the safety clip off-center
Safety
Clip
Holder A
Output
Shaft
Center the
safety clip
Safety
Clip
Blade
Slide the blade in place
Output
Shaft
Blade
Holder B
Install the blade holder
Output Shaft
Safety
Clip
Hex Wrench
(blade not
shown for
clarity)
Bolt Guard
Tighten the blade
holder assembly