Operator`s manual

7
C242 Brushcutter
An Emission Control Label is located on the engine.
(This is an EXAMPLE ONLY, information on label varies by engine FAMILY).
PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)
The 50 or 300 hour emission compliance period is the time span selected by the manufacturer
certifying the engine emissions output meets applicable emissions regulations, provided that
approved maintenance procedures are followed as listed in the Maintenance Section of this manual.
Emission Control (Exhaust & Evaporative)
EPA 2010 and Later and/or C.A.R.B. TIER III
The emission control system for the engine is EM (engine modication) and, if the second to last character
of the Engine Family on the Emission Control Information label (sample below) is “C”, “K”, or “T”, the
emission control system is EM and TWC (3-way catalyst). The fuel tank/fuel line emission control system is
EVAP (evaporative emissions). Evaporative emissions for California models are only applicable to fuel tanks.
EMISSION CONTROL INFORMATION
ENGINE FAMILY: CEHXS.0214KL DISPLACEMENT: 21.2cc
EMISSION COMPLIANCE PERIOD: 50 Hours
THIS ENGINE MEETS 2014 U.S. EPA EXH/EVP & CALIFORNIA
EXH/EVP EMISSION REGULATIONS FOR S.O.R.E. REFER TO OWNER’S
MANUAL FOR MAINTENANCE SPECIFICATIONS AND ADJUSTMENTS.
JAN 2014
EMISSION CONTROL INFORMATION
ENGINE FAMILY: CEHXS.0214KL DISPLACEMENT: 21.2cc
EMISSION COMPLIANCE PERIOD: 300 Hours
THIS ENGINE MEETS 2014 U.S. EPA EXH/EVP & CALIFORNIA
EXH/EVP EMISSION REGULATIONS FOR S.O.R.E. REFER TO OWNER’S
MANUAL FOR MAINTENANCE SPECIFICATIONS AND ADJUSTMENTS.
JAN 2014
Contents
The Shindaiwa product you purchased has been factory pre-assembled for your convenience. Due to
packaging restrictions, debris shield installation and other assembly may be necessary.
After opening the carton, check for damage. Immediately notify your retailer or Shindaiwa Dealer of
damaged or missing parts. Use the contents list to check for missing parts.
____ 1 - Power head / Drive shaft assembly
____ 1 - Handlebar and throttle assembly
____ 1 - Debris shield assembly
____ 1 - Trimmer head
____ 1 - Trimmer head spacer
____ 1 - Drive shaft cushion
____ 1 - Shoulder strap
____ 1 - Safety glasses
____ 1 - Assembly tool(s)
____ 1 - Operator’s manual
____ 1 - Emission control warranty statement