Use and Care Manual

DH235 OPERATION

X7712240300 23

2. Stop Switch

Move stop switch (A) to STOP

position.

If engine does not stop when stop switch is moved to STOP

position, close choke - COLD START position - to stall engine.

Have your dealer repair stop switch before using unit

again.

Rotating operation

This model is equipped with a

roating throttle handle that can be

turned 90° to either side of vertical

operating position to help reduce

operator fatigue and improve

precision trimming.

Always stop the engine before rotating the handle!

Failure to do so could result in serious injury.

To operate

1. Fully release throttle trigger.

2. Push handle release lever.

3. Rotate the handle 90° in the

desired direction and release the

lever. Make sure that the handle

is fully locked into position before

use.

Note: The throttle trigger will not

operate when the throttle

handle is not fully locked

into position.