Saw User Manual

NOTE:

For units equipped with a water kit,

loosen the (2) water nozzles and

disconnect the main water line from

the double nozzle.

1. Remove the cutting wheel (See

pages 10 and 11). Using a Phillips

screwdriver, loosen the tension

screw until the tension indicator is

all the way to the front of the scale.

See Figure 15.

Figure 15

Figure 18

4. Remove the blade mount from the

mounting surface and rotate the

blade mount 180

, then remount to

the right hand side of mounting

surface. See Figure 18.

Reversing cutting head for flush cutting operations

Tension Screw

Tension

Indicator

Belt Guard

WARNING!

Before performing any work on the cut-off saw, make sure the engine is

stopped and the ignition switch is OFF.

Remove Cutting Wheel

Loosen

Two Bolts

2. Back off tension screw another 4-5

turns so that adequate clearance is

achieved where the tension screw

contacts the mount when the mount

is turned over. See Figure 16.

Figure 16

Mount

Tension Screw

Figure 17

3. Using a 6mm hex wrench, remove

the two belt guard bolts and slide

the belt guard forward to remove.

See Figure 17.

6mm Socket-

Head Bolts