Owner's Manual

T3000 SAFETY
X7508162400 9
© 07/2016 ECHO Inc.
Equipment
Avoid unnecessary impact and abusive treatment. Unit contains electronic components.
• Avoid Dangerous Environment – DO NOT use unit in damp or wet locations.
• DO NOT use unit in the rain.
Keep Children Away – All visitors should be kept at a distance from work area.
Use Correct Unit – Use unit only for its intended purpose. Do not use unit as an edger.
DO NOT Force Unit – It will do the job better and with less likelihood of a risk of injury at the rate for
which it was designed.
Use only SHINDAIWA attachments. Serious injury may result from the use of a non-approved
attachment combination. ECHO, INC. will not be responsible for the failure of cutting devices,
attachments, or accessories which have not been tested and approved by ECHO. Read and comply
with all safety instructions listed in this manual.
• Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing, and loose
objects away from all openings.
• ALWAYS turn power to unit off, remove battery, and make sure all moving parts have come to a
complete stop before removing obstructions, clearing debris, cleaning, or servicing unit.
• Avoid Unintentional Starting – DO NOT carry unit with the power indicator LED illuminated. Be
sure power indicator LED is off when carrying the unit.
• Store Idle Unit Indoors – When not in use, units should be stored indoors in a dry, and high or
locked-up place – out of reach of children.
• To reduce the risk of injury to persons, do not operate without debris shield installed.
• Check unit for damage, especially if the unit is dropped. If damage is found, do not use unit,
otherwise serious personal injury or property damage may occur. Have unit repaired by an
authorized servicing dealer before using.
• Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.
• Check that the cutting head is firmly attached and in safe operating condition.