Instructions / Assembly

TOOLS NEEDED: Philips screwdriver, power drill optional

CAUTION: When assembling chair, DO NOT completely tighten the bolts and nuts until

all the parts & holes are properly aligned.

How To Assemble Your Rocking Chair (REV. 12/2016)

This chair is not recommended for weight of more than 250lbs.

Care should be taken to avoid tipping while seated.

This chair is designed for use on level ground only. Do not use on unlevel ground.

To avoid harm or injury - do not sit on arms.

Product is for residential use only - not meant for commercial use.

Step 1:

Attach Seat (A) to the Back (C) with 2 bolts (I) & 2 Spring Washers (J) by using the

Allen Wrench (N).

Bolt (I) &

Spring Washer (J)

Bolt (I) &

Spring Washer (J)

PAGE 1
How To Assemble Your Rocking Chair (REV. 12/2016) TOOLS NEEDED: Philips screwdriver, power drill optional CAUTION: When assembling chair, DO NOT completely tighten the bolts and nuts until all the parts & holes are properly aligned. This chair is not recommended for weight of more than 250lbs. Care should be taken to avoid tipping while seated. This chair is designed for use on level ground only. Do not use on unlevel ground. To avoid harm or injury - do not sit on arms.
PAGE 2
Step 2: Put the 2 Railds (D) & the Front Frame (B) to the corresponding place, connect 2 Rails (D) & the Front Frame (B) with 4 Screws (L) then tighten with 2 Bolts (I) and 2 Spring Washers (J) by using the Allen Wrench (N). A B Long Screw 4x45 mm B L J Bolt (I) & Spring Washer (J) Long Screw 4x45 mm J I I D D L Long Screw 4x45 mm C L L Long Screw 4x45 mm Step 3: 1. Attach the Left & Right Arms (E, F) as pictured below.