Instruction manual

Shinepal Electronics Co., Ltd
www.shinepal.com
z To deactivate or delete the panic alarm receiver(s),
Send:”000000H” SMS to console phone number
Confirmation: user will receive a SMS for confirmation as H-Deleted to indicate programming is successful.
Note:
a.119 is local emergency line and should be authorized by related department, such as police station, before
programmed.
b. Strongly recommend not to program receivers who live within same premise. Thus, intruder would know
that owner has initiated emergency call when user’s phone rings.
Note: When setting the emergency call as 110, please be careful to use emergency call, must prevent false
alarm and has to get approval of local police , you can have 5 emergency call numbers, it will be dialed sequencially
follow the setting you made until the phone number you set has been pick up or hang up, or it will re-dail for 10
cycles. Emergency call number is not proper to set user’s own mobile number to avoid reminding the criminals at
the site, it’s better set as 110 or your relative not at the site.
2-2-6 A: To Activate/Release the System
You can Activate/Release the system by sending SMS or using remote control unit when you are leaving the
premise. Arming or disarming is to activate or deactivate the built-in heat & motion detector. Refer to Section 2-3-1
for the remote control unit Operation.
z Activate the system
Send: “000000A1” SMS to console phone number
Confirmation: administrator will receive a SMS for confirmation as detector on
If any moving object, i.e. intruder, is detected, system will process alarm alert as programmed.
z Release the system
Send: “000000A0” SMS to console phone number
Confirmation: administrator will receive a SMS for confirmation as detector off
System will not process any alarm alert If any motion is detected
2-2-7 D: To Check System Settings
z You may check and review system present settings at any time
Send: “000000D” SMS to console phone number
Feedback example as follows:
Ver: YJ5.3 sound open, detector on, jpg:320*240 N：111111
M：#0932345678, 0935111111 E: [e-mail], [e-mail] H :
110, 0938666666
2-2-8 T: To Listen in
Sender can assigned any phone set or mobile phone number followed command T.
z User with phone number 0923999999 intends to listen in the premise,
Send: “000000T0923999999” SMS to console phone number
In 1 minute, system will call the phone number received for the user to listen in the premise.
2-2-9 1—7Supervise the Site
Send“00000002” SMS to console phone number
000000 is default password, take two pictures, and then send to caller and email address programmed.
2-2-10 C: To Reset the System
z To clear all present system setting and revert to factory default,
Send: “000000C”SMS to console phone number