Instruction manual

Shinepal Electronics Co., Ltd
www.shinepal.com
Within transmission range, press and hold the button for 3 seconds to initiate
emergency alert. If it is answered the monitor unit will broadcast the pre-record
voice to give the warning messages.
2-3-2 Enrollment
If you are not able to operate the remote control unit(s) normally after system resetting or adding new one(s),
you need to re-enroll the remote control unit (s) to system. Instruction is shown as follows.
● Power the system, turn on power switch, and wait for system initialization
completed (3 long beeps heard).
● After system initialization, use a conductive object, i.e. screw driver, to short 2 pins, located as sign pointed
and circled at the drawing below, and remove the object immediately after a short beep is heard. Within 15
seconds, press any button continuously to register the remote control unit to system. You may stop pressing the
button when a long beep is heard to indicate the remote control unit registration successful.
Interface configuration
● Follow the steps above to register all the remote control units up to 10 to system.
● If any remote control units is lost, you may delete all registered remote control units, instruction as below and
follow the steps above to re-register the rest remote control units to system again.
1. Use a conductive object, i.e. screw driver, to short 2 pins, located as sign pointed and circled at the drawing
above,
2. Remove the object immediately after a long beep is heard.
3. Follow the remote control unit registration procedure to re-enroll them to system.
● System should be rebooted after all remote control units are registered.
2-4 Extension unit operations (Reserved function for future version)
While you have the console, you still can install the extension units within the effective distance, extension units
has SMS unit and Video unit two different types：
SMS unit is to give alarm massages thru SMS（see2-2-11 U— SMS alarm settings）
For example : #2 extension alarm has been triggered you can receive the messages on your mobile with
following SMS：
“No.2 give alarm”
Video extension is giving image alarm messages.
Extension units must do the channel matching with the console before use, it’s similar with the way we did for the
remote control unit：
Put the two pins under the mark under the console make them short circuit (one touch each other) and
released, you will get a beep sound from the console, then switch ON the power of extension unit in 15 sec. It
response, when you get a long beep from the console means the channel matching is success.
The installation environment of extension unit is the same as the master unit, but the distance between master
and extension unit can’t not over 80 meters (80 meters without any thing blocked) radio wave will be affected by the
environment and the distance.