Instruction manual

Shinepal Electronics Co., Ltd
www.shinepal.com
3. Notes
3-1 Location for the System
⑴ Selecting proper location for system installation, you should check the GSM/GRRS signal before installing. You
may use your mobile phone with signal strength indicator to check if signal strength of location is strong or not.
⑵ Electricity power, AC110/220V, should be easy to access.
⑶ System is designed for indoor application, not for outdoor.
⑷ Location should keep away from air-conditioner outtake, steamy area, heat zone, and electromagnetic area.
⑸ System should avoid facing the direct sunlight or being blocked by other object.
⑹ System should avoid facing the area and passage of pets and sun light.
⑺ System should avoid facing transparent window directly.
3-2 Data Transmission and MMS Activation(Refer to last section 3-9)
Users’ mobile phones should feature GPRS MMS and SMS, and CSD digital data transmission is activated. In
addition, the phone set should be programmed properly for GPRS/MMS/SMS operation.
Due to difference of telecommunication service providers and mobile phone models, please consult with service
provider for programming.
3-3 Notes for Console’s SIM
1). If site supervision is frequently used, please select the higher packet rate of telecommunication service. If
not frequently use, basic rate will be enough to cover.
2). For saving on telecommunication, disable the feature of Caller ID of console. If so, only SMS can operate and
program the system.
3). Before inserting the SIM to the console, unnecessary features, i.e. voice box and call waiting, should be
disabled at a mobile phone. Insert the SIM to any mobile phone and contact service for correct procedures.
4). Refer to user instruction of mobile phone to disable the PIN for the SIM.
3-4 Solution for Password Forgotten
If the password is forgotten or missing, you may follow the steps to reset the password.
1). Press and hold the Disarm/Test button on any registered the remote control unit for 3 seconds; a long beep
is heard to indicate system is entering test mode.
2). Short the pins at the connector shown as the following drawing with a conductive object, such as a screw
driver; a long beep is heard again to indicate the password has been reset and reverted to default password,
000000.
3). Press and hold the Disarm/Test button on any registered the remote control unit for 3 seconds; a long beep
is heard to indicate system is back to standby mode.
4). Reboot the system for operation or programming.
Caution: Don’t short other pins on the connector and touch other metallic object during resetting.
3-5 FAQ
Q1. System doesn’t initialize after rebooting.
A1: Switch off the power, remove the power cord, the backup battery, and check if SIM is inserted properly.
Re-power the system after 3 minutes.