Instruction manual

Shinepal Electronics Co., Ltd
www.shinepal.com
Q2. The remote control unit doesn’t work.
A2: Check if battery or the remote control unit fails. If not, reboot the system to solve the question. If problem still
exist, re-enroll the remote control unit to the system.
Q3. System is not working
A3: Check if system is in testing mode, the bill of console telecommunication paid, or PIN for the SIM card does not
disabled. If none of above condition, reboot the system. If junk SMS has occupied the memory of system, you
clear the memory by rebooting the system.
3-6 Installation Location
Mobile Monitor 18 is for indoor application. Detection range, sensitivity, and false alarm are decided by the
installation location. The following are strongly recommend for selecting location and installing the system.
1). Sensitivity of heat detection is decided by the direction of the moving object. If the object is moving towards
to the lens of the console, sensitivity of heat detection will be less accurate than moving cross the zone.
Shown as Fig-1
Fig-1
2). System should face potential cross passage of moving object.
3). Recommended height for installation is 2.0~2.2 meters to cover maximal detection area shown as Fig-2.
Fig-2
4). Console should keep away from air-conditioner, refrigerator, heater, gas burner, or some other heat radiation
source, which will affect detection sensitivity and cause false alarm.
5). Console lens should not be blocked by blockades such as shield, plants, or other furniture.
6). Console should avoid facing window directly, which outdoor air flow or other moving object will cause false
alarm. Before arming the system, pull curtain or blind to cover the window for better performance.
7). Console should avoid the location of high density RF, heat radiation, or strong air flow.
Fig-3