Instruction manual

Shinepal Electronics Co., Ltd
www.shinepal.com
2-1 Major Function
2-1-1 Active reviewing function
User can supervise the site by calling the console or sending SMS to console. Instructions are as follows.
A. By Calling
Make sure the feature of MMS is activated for both caller and the console. You just call the console phone number, and
console will pick up, confirm, and hang up the call. After taking a picture of the premise, console will send the picture
to the caller and the first email address if any email address has been programmed. If system authority level has
been programmed as administrator and other user(s), only the administrator can perform this feature by calling and
sending SMS plus password for other user(s).
B. By Sending SMS
Format: 0X
Where
0 (zero): command for sending picture of premise
X: quantity of picture required to review from 1 to 9
Ex: Send“00000002” SMS to console phone number
000000 is default password, the 7
th
show Console, Console will process SMS received, take two pictures, and then
send to caller and email address programmed.
Note:
1. If none phone number is programmed as alert receiver, any mobile phone with feature of MMS activated can
perform this function. Only the administrator and user(s) can do so when receiver phone numbers are
programmed.
2. Caller ID and MMS should be activated, and Voice Box and Call-Waiting should be deactivated for the console.
2-1-2 Infrared Heat & Motion Dual-Tech Detection
Infrared heat & motion is active under system arming mode to detect any motion object in the premise. If any
motion object, i.e. intruder, is detected, system will send 3 pictures to designated receiver(s). There is 3 seconds
of time interval between the first and second shot; the third shot will be sent after the strobe starts to work. After
sending pictures, system calls each receiver and play pre-recorded vocal message if the line is through. 十分钟
内不再触发报报警。
2-1-3 Emergency call key
Under panic or emergency circumstance, such as duress or intrusion, you can press and hold the emergency button
on the remote control unit for 3 seconds to initiate a silent alarm and alert designated emergency alarm receiver, and
system plays 3 cycles of vocal emergency message when the line is through. Meanwhile, all receivers of designated
phone and email address will have picture of premise and vocal emergency alarm alert as well. If line is not through,
system will terminate alerting after 5 attempts of calling in 3 minutes of time interval. Refer to Section 2-2-5 for
details of programming emergency alarm receiver and Section2-3-1 for remote control unit operation.
2-1-4 Listen in
You just need to send the SMS to the console, and you will receive call back for the receiver to listen in the sound of
premise. You can send SMS: "T+ telephone number or mobile phone number," in one minute console will phone the
number behind of the "T". Users receive, they can monitor the voice of the scene. Send SMS: "T", console will call the
mobile phone number which send SMS.
2. Operation