Owner's Manual

STEP 11

BB M6 x 12 Bolt 6pcs

M4 x 8 Bolt

Hardware Used

1pc

M4 Cap Nut 1pc

Slide hopper gasket over auger housing. Then place the pellet hopper assembly onto the cooking

chamber (#27) by inserting the auger housing through the left endcap. While holding the hopper

assembly away from the endcap, insert the grill probe (#46) through the endcap wall. The grill probe

(#46) should be turned horizontal, as shown in the figure. Tighten the grill probe (#46) into place using

(1) M4 x 8 bolt (EE) and (1) M4 cap nut (AA).

NOTE: Make sure grill probe tip end is facing towards the chamber front when installing.

Tighten the hopper assembly to the cooking chamber (#27) left endcap using (6) M6 x 12 bolts

ASSEMBLY INSTRUCTIONS