Operation Manual

1) When either of alarm lamps (I)(J)(K)(L) lights up, it stops output current.
2) Remedy the cause.
3)Push Reset Switch (M).
The lighting alarm lamp put off.
4) Push Start Switch (O).
Again, the output current flows.
SECTION5. TROUBLESHOOTING
Table-1 TROUBLESHOOTING
SECTION6. SPARE PARTS LIST
Table-2 SPARE PARTS LIST
SECTION7. BLOCK DIAGRAM
10
3) Power-output of Distribution Panelfor OHVC
Circuit Breaker MCB14
L13
L23
GND
4) Power-output of Power Supply
Terminal Block TB21
U
V
GND
5) Connection with OHVC
Terminal Block TB22