Operation Manual

1) When either of alarm lamps (I)(J)(K)(L) lights up, it stops output current.
2) Remedy the cause.
3)Push Reset Switch (M).
The lighting alarm lamp put off.
4) Push Start Switch (O).
Again, the output current flows.
SECTION5. TROUBLESHOOTING
Table-1 TROUBLESHOOTING
SECTION6. SPARE PARTS LIST
Table-2 SPARE PARTS LIST
SECTION7. BLOCK DIAGRAM
17
Before this operation, it supposes that the installation of the equipment, the wiring and
the early adjustment have completed.
4-1Switch Panel Unit
1)Open the door of Distribution Panel Unit.
Turn on Circuit Breakers (T)(U)(V).
2)Close the door of Distribution Panel Unit.
Make Handle (A) the position of ON .
Circuit Breaker (R) becomes ON with the handle.
Lamp (B) lights up.
3) Push Power Switch (D).
Magnet Contactor(S) turns on.
Lamp (C) lights up.
4) Push Power Switch (E).
Magnet Contactor(S) turns off.
Lamp (C) put out.
5) In case of work ending, make the Handle(A) OFF position.
All power supplies become OFF.