Operation Manual

FCC ID : OPO199909010001

KEN72-3699(E)Rev.0

5Auto Mode and Manual

5.1 Operation mode of the Vehicle

Operation mode of the Vehicle is shown in Fig. 5.1

Fig. 5.1 Operation mode of the Vehicle

5.2 Auto mode

(assumption : Vehicle has already moved in the OHT main track)

(1) Change the key switch of the control panel to “Auto”

(2) Send a entry command from OHVC

--- The vehicle start to run in order to search position ID(Bar Code Label)

If the vehicle searched BCL, the vehicle stop at that position.

(3)Control by the OHVC

After then, the vehicle will be controlled by the OHVC.

5.3 Manual mode

In this mode, the vehicle is controlled by the remote control box.

There are two method to inter this mode.

(1) Change the key switch of the control panel to “Local”

(2) Send a message to change “Local” from OHVC

As to the operation of the remote control box, refer to the “operation manual of the remote

control box”