Datasheet

3
3.1 Operation flow chart
PV/SV display mode
(Approx. 3s)
Control output MV indication
+ + (Approx. 3s) + (Approx. 3s)
[Main setting mode] [Sub setting mode] [Auxiliary function setting mode 1] [Auxiliary function setting mode 2]
Main setting
[ ]
PID auto-tuning Perform/Cancel
[ ]
Setting value lock selection
[ ]
Sensor selection
[ ]
Proportional band setting
[ ]
Sensor correction setting
[ ]
Scaling high limit setting
[ ]
Integral time setting
[ ]
Instrument No. setting
[ ]
Scaling low limit setting
[ ]
Derivative time setting
[ ]
Data transfer rate selection
[ ]
Decimal point place selection
[ ]
Anti-reset windup setting
[ ]
PV filter time constant setting
[ ]
Proportional cycle setting
[ ]
Control output high limit setting
[ ]
Manual reset setting
[ ]
Control output low limit setting
[ ]
Alarm setting
[ ]
Control output ON/OFF action
hysteresis [ ]
Heater burnout alarm setting
[ ]
Alarm action selection
[ ]
Loop break alarm time setting
[ ]
Alarm action
Energized/Deenergized [ ]
Loop break alarm action span
setting [ ]
Alarm HOLD function selection
[ ]
Alarm hysteresis setting
[ ]
Alarm action delayed timer
setting [ ]
Setting value digital transmission
bias setting [ ]
Direct/Reverse action selection
[ ]
Controller/Converter function
selection [ ]
AT bias setting
[ ]
• + : Press the key while the key is being pressed.
• + (Approx. 3 seconds): Press the key while the key is being pressed.
• + (Approx. 3 seconds): Press the key while the key is being pressed.
For setting and selecting in each setting mode, press or key.