User Manual

− Installing the Battery
Before you can start using your phone, you must install and charge the battery. The battery should
be fully charged before using the phone for the first time. Otherwise, the service life of the battery
may be reduced.
Only use the charger supplied with the phone to charge your phone. Using a different charger could
damage the phone.
• Remove the battery from its protective bag.
• Slide the battery into the connector at the back of the phone, then press the top of the
battery firmly into place.
− Charging the Battery
• Plug the charger into the charger connector at the base of the phone.
• Plug the other end of the charger into an electrical outlet.
The battery begins to charge and the charging LED appears on the display.
• When the battery level indicator shows that the battery is fully charged, disconnect the
charger.
Notes
<TBD>
Cautions
<TBD>
− Attaching the Wrist Strap
• Feed the tip of the strap through the wrist strap hole, then feed the strap through the loop.
• Pull the strap to make sure the strap is secure.
o Turning Your Phone On and Off
After turning on your phone and checking that you can connect to the network, you should take the
time to personalize the settings to your needs.
To set the data and time for the phone, see “” on page X.
To change the PIN codes from their default settings, see “” on page X.
To change the language for the phone, see “” on page X.
− Turning the Phone On
• Press and hold the <END/PWR> key to turn on your phone.
The phone comes on and then the name of the service network is displayed.
If the “PIN” Message Appears
The SIM card may be protected with a PIN code to prevent unauthorized use of the phone. If this is
the case, the message “PIN” will appear on the display.
To enter the PIN and use the phone:
• Enter your PIN code to start using the phone.
If you make a mistake when entering the PIN code, erase the incorrect number by pressing
“X”..
• Press OK.
The phone is unlocked and searches for a service network.
Note: