User's Manual

BT-MC88-1X User manual
4
Tstg Max 85
℃
20 mins, Temperature shift time: within 5 mins. Tstg Min -40
℃
20
mins. 50 cycles
6
静电测试
Electrostatic Resistance
人体接触放电
±2KV
，
3
次，静电测试后，在标准测条件下，模块应满足基本功能
human body model ±2KV, 3 times
7
振动测试
Vibration Resistance
振动频率：
10
～
55Hz
，扫频速率：
0.1 oct/min
，最大加速度：
4G
。
X
，
Y
，
Z
三个
方向各两个小时，振动完成后，在标准测试条件下三个小时内测试，满足基本功能
Freq: 10~55Hz, 0.1 oct/min, max acceleration: 4Grms- Test time: X,Y, Z axis for 6
hours. After 1 hour vibration test, do the test in each direction. In standard test condition,
take measurements within 3 hours.
8
冲击测试
Impact Resistance
冲击测试：冲击加速度：
50G(m/sec2)
；冲击时间：
11
毫秒；冲击频率和方向：
6
个方向每个方向
10
次。在标准测试条件下三个小时内测试，模块应满足可靠性测
试标准 跌落测试：将模块从
100
厘米的高度跌落到一块
10
毫米厚的胶合板上，
重复
5
次，实验完成后在标准测试条件下，模块应满足基本功能
Shock Test: Impact acceleration: 50G(m/sec2), impact time: 11msec, impact frequency
and direction: 10 times each in 6 directions. In standard test condition, take
measurements within 3hr. Drop Test: Test height: 100cm. Frequency: 5 times. Drop the
module onto 10mm thickness plywood. In standard test condition, take measurements
within 3 hours
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
FCC Radiation Exposure Statement
This modular complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
If the FCC identification number is not visible when the module is installed inside another device, then the
outside of the device into which the module is installed must also display a label referring to the enclosed
module. This exterior label can use wording such as the following: “Contains Transmitter Module FCC ID:
ZWY88112 Or Contains FCC ID: ZWY88112 ”
When the module is installed inside another device, the user manual of the host must contain below
warning statements;
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired
operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
The devices must be installed and used in strict accordance with the manufacturer's instructions as
described in the user documentation that comes with the product.