Instruction manual

RS-232 SERIAL INTERFACE
RS-232 PROTOCOL COMMANDS ( RS232 Control driver V2.0.1 )
The Shinybow switcher can be controlled via the RS-232 serial control port to allow for interfacing to a PC,
The serial communication parameters are 9600 baud, 8 bit, No Parity and 1 stop bit - this is often referred to as 9600 8N1.
When the unit recognises a complete command it will perform the requested action - there is no delimiter character required.
or similar third party control system.
RS-232 SERIAL INTERFACE CONNECT a PC or CONTROL SYSTEM. VERSION COMPATIBLE V2.0.1
1
RS-232 SERIAL INTERFACE
Pin RS-232 Definition
1 ------ Not used
2 TX Transmitter
3 RX Receiver
4 ------ Not used
5 GND Ground
6 ------ Not used
7 ------ Not used
8 ------ Not used
9 ------ Not used
PAGE 22 SB-5645 INSTRUCTION & OPERATION MANUAL
For a complete list of commands, please reference external document extended RS-232 Protocol Instruction Manual.
2 3 4 5
6 7 8 9