Instruction manual

ManualsBrandsShinybow USA ManualsAmplifierSB-5654

P a rt N o. : E N C L 0 0 5 6 54 0 0 0 A 0

Tha nk y o u fo r p urc ha sin g the SB- 5654 HDM I Distrib uto r A m p lifie r. Y o u w ill find this un it e a sy to insta ll

a nd hig hly re lia b le b ut it is e sse ntia l th a t y o u re a d this m a nua l thro ug hly b e fo re a tte m p ting to us e

1x 4 HDM I Distrib utio n A m p lifie r.

H DMI D is tr ib ut io n A mpl i er S er ie s

1 x4 HDM I DISTRIBUTIO N AM PLIFIER

HIG H-D EF INI TIO N MU LTIM ED IA IN TE RF AC E

V E R S I O N L E V E L : V 1 . 3

MOD EL : SB -565 4

Instruction Manual

M U L T I M E D I A A U D I O A N D V I S U A L

Summary of content (12 pages)

PAGE 1
HIG H-D EF INI TIO N MU LTIM ED IA IN TE RF AC E MU LT IME DIA AU DIO AND V IS U AL V E R S ION LE V E L : V 1.3 Instruction Manual MOD EL : SB -565 4 1 x4 HDM I DISTRIBUTIO N AM PLIFIER H D MI D is tr ib ut io n A m pl ifi er S er ie s Tha nk y o u fo r p urc ha sing the SB- 5654 HDM I Distrib uto r A m p lifie r.
PAGE 2
SAFETY INFORMATION 1. Save the carton and packing material even if the equipment has arrived in good condition. Should you ever need to ship the unit, use only the original factory packing. 2. Read all documentation before operating your equipment. Retain all documentation for future reference. 3. Follow all instructions printed on unit chassis for proper operation. 4. Do not spill water or other liquids into or on the unit, or operate the unit while standing in liquid. 5.
PAGE 3
TABLE OF CONTENTS TABLE OF CONTENTS 3 INTRODUCTION 4 FEATURES & SPECIFICATIONS 5 FRONT PANEL 6 REAR PANEL 7 REMOTE CONTROL 8 TYPICAL APPLICATION 9 LIMITED WARRANTY 10 POWER AND CONNECTIONS This unit is not disconnected from the AC power source as long as it is connected to the wall outlet. The off state for this unit is called standby mode. In standby mode the unit is designed to consume a reduced quantity of power compared to normal operating modes.
PAGE 4
INTRODUCTION INSTRUCTION The SB-5654 is high quality HDMI distribution amplifier, HD high performance designed to distribution HDMI signal. Providing I/O as following : > 1x input : 1x HDMI (Digital Video-TMDS and Audio) > 4x outputs : 4x HDMI (Digital Video-TMDS and Audio) Automatic input/output HD signals detection: > PC monitor from VGA to UXGA > HDMI 480i To 1080p > DVI 480i To 1080p The distributor support data rates up to 2.25 Gbps.
PAGE 5
FEATURES & SPECIFICATIONS FEATURES 1. 2. 3. 4. 5. Support 1x4 HDMI Distribution Amplifier I/O Signals : HDMI with HDCP Digital Video and Digital Audio (PCM) HDMI and HDCP compliant Support link speeds of up to 2.25 Gbps (link clock rate of 225 MHZ) Support wide range of PC resolutions from XGA to UXGA 1600x1200 and HDTV/DTV resolutions 480i/480p, 576i/576p, 720p, 1080i & 1080p 6. Compatible with all HDMI devices, PC monitors, Plasma TV display and HDTV 7.
PAGE 6
FRONT PANEL FRONT PANEL IR SB-5654 1 2 3 4 1x4 HDMI DISTRIBUTION AMPLIFIER POWER 1 1 2 POWER ON SWITCH 3 4 3 The IR sensor receives IR commands from the supplied remote controller. The power switch turns the unit on and off. The LED will illuminate red to indicate that the switcher is ON and is receiving power 2 INPUT SOURCES STATUS DISPLAY Input source 1 to 4 LED illuminates blue to indicate that a video source is present on that input.
PAGE 7
REAR PANEL REAR PANEL RoHS/95/EC OUTPUT- 4 OUTPUT- 3 OUTPUT- 2 OUTPUT- 1 INPUT HDMI HDMI HDMI HDMI HDMI INPUT DC 12V 3 1 2 1 DC POWER INLET The distributor is fitted with a DC power plug-park input connector. Please ensure that the plug-park used is of an approved type and is of sufficient current carrying capacity with the correct voltage and connector polarity. 12Volt DC power supply 1A~2A Max. Power Jack: DC Jack - inner OD O 2.1mm (+ ) Outside OD O 5.
PAGE 8
REMOTE CONTROL Before making any connections to the SB-5654. Observe the following: > Ensure the mains voltage supply matches the label on the supplied plugPack (+/- 10%) > Connect all audio video sources and destination equipment > power up all source and destination audio-visual sources > Ensure that the power switch is OFF > For each destination output select the appropriate input source by using > Ensure that all system grounds (earth) are connected to a common point.
PAGE 9
TYPICAL APPLICATION 1x HDMI source to 4 x HDMI displays Distribution Amplifier SHINYBOW SB-5654 OUTPUT 1234- INPUT HDMI DISPLAYs DV D HDMI Player INSTALLING INPUT PORT SIGNAL : 1. HDMI - HDMI connector with fix screw OUTPUTS PORT SIGNALS : 1. HDMI - HDMI connector with fix screw 2. HDMI - HDMI connector with fix screw 3. HDMI - HDMI connector with fix screw 4.
PAGE 10
LIMITED WARRANTY SHINYBOW WARRANTY SHINYBOW Technology warrants this product against defects in materials and workman ship for a period of 1 year from the date of purchase. Should this product, in SHINYBOW Technology,s opinion, Prove defective within this warranty period, SHINYBOW Technology, at its option, repair this product without charge, to whatever extent it shall deem necessary to restore said product to proper operation condition.
PAGE 11
PAGE 12
MU LT IME DIA AU DIO AND V IS U AL 1399 Wildfire Lane | Frisco, TX 75034 1-877-SHINY-USA 1-877-744-6987 1-972-377-2508 sales@shinybowusa.com www.shinybowusa.