• User Manual • SC3130 Caller ID Phone
SC3130 User Guide ! • Please ensure the phone is placed in a dry and ventilated place without corrosive air. • Please install 3 x AA batteries for viewing the LCD display. If the LCD does not display clearly, please change the batteries. • Please check if you had applied caller ID service from Telecom provider for caller ID display.
SC3130 User Guide TABLE OF CONTENT PRODUCT OVERVIEW ..................................................................................... 3 1. INSTALLING OR REPLACING THE BATTERY ......................................................... 4 2. SWITCH OPERATION................................................................................... 4 IDD LOCK switch....................................................................................... 4 3. SOFTWARE SETTING ...........................................
SC3130 User Guide PRODUCT OVERVIEW 18 19 20 17 16 15 14 1 2 3 4 13 5 6 7 8 9 12 11 10 Description: 1. LCD Display 16. OUT/x key 2. DOWN/+ key 17. UP/- key 3. DEL key 18. TEL LINE jack 4. RING/HOLD key 19. TEL LINE jack 5. SET key 20. LOCK switch 6. BRIGHT/÷ key 7. FLASH key 8. REDIAL/BACK key 9. HF (HANDSFREE) key 10. #/= key 11. 0-9 key 12. */. key 13. Handset Cord jack 14. CAL key 15.
SC3130 User Guide 1. INSTALLING OR REPLACING THE BATTERY Install 3 Alkaline AA batteries into the battery compartment and re-fit the cover before use. IMPORTANT—before removing the battery compartment cover, ensure the base unit is disconnected from the telephone line. Connection and conditions for use You can connect your SC3130, to public networks in the United Kingdom or to an approved PBX using DTMF signaling. Each item of telephone equipment (phones, fax machines, etc.
SC3130 User Guide AREA CODE LCD panel display SET 2 CODE, press SET key to confirm, LCD display CODE, press SET key to enter this mode. Use UP/- or DOWN/+ key to select value, then press SET key to move to next item. Area Code can be used to filter the number for incoming calls. E.g. Area code = 75 when there is incoming call with 75 6554556, it will be displayed as 655 4556 only. PABX CODE LCD panel display SET 3 PCODE, press SET key to enter this mode.
SC3130 User Guide 4. FUNCTION KEY OPERATION UP/- key and DOWN/+ key In any mode, press either key to check all the incoming numbers. If there is no incoming number, the unit will display END. The unit can receive up to 16-digit phone numbers. OUT/x key In any mode, press OUT key to check the outgoing numbers with time. Use UP/- or DOWN/+ key to select the outgoing number. Press BACK key to dial the selected number.
SC3130 User Guide RING/HOLD key again. FLASH key (600ms) In the on-hook mode, press this key to auto-hang up for 600ms, after that you can press REDIAL key or dial out another number. REDIAL/BACK key In the on-hook mode, pre-dial the number then press REDIAL/BACK key to auto pick up and dial out the number. In the off-hook mode, press this key to redial the last dialed number. When checking the incoming number or outgoing number, press REDIAL/BACK key to auto pick up and dial out the number directly.
SC3130 User Guide check with your local dealer. (Q) I cannot hear the VIP ringing tone when there is a VIP incoming call. (A) Ensure that you have inserted the batteries on the battery compartment. If there is still no VIP ringing tone, change the batteries and ensure it is not empty. If the problem persists, please check with your local dealer.
