• User Manual • SC3123 Caller ID Phone
SC3123 User Guide ! • Please ensure the phone is placed in a dry and ventilated place without corrosive air. • Please install 3 x AA batteries for viewing the LCD display. If the LCD does not display clearly, please change the batteries to ensure the normal function of the unit. • Before operation, please check if you had applied for caller ID service from Telecom for caller ID display.
SC3123 User Guide TABLE OF CONTENT PRODUCT OVERVIEW ..................................................................................... 3 1. INSTALLING OR REPLACING THE BATTERY ......................................................... 4 2. SWITCH OPERATION................................................................................... 4 IDD LOCK switch....................................................................................... 4 3. SOFTWARE SETTING ...........................................
SC3123 User Guide PRODUCT OVERVIEW 14 15 16 1 2 3 4 13 5 6 12 11 10 9 8 7 Description: 1. LCD Display 11. UP key 2. SET key 12. OUT key 3. IP key 13. Handset Cord jack 4. FLASH/RING key 14. LINE OUT (TEL) jack 5. AUTO-RD REDIAL/BACK key 15. LINE IN (TEL) jack 6. HF (HANDSFREE) key 16. LOCK switch 7. 0-9/#/* key 8. PAUSE key 9. DOWN key 10.
SC3123 User Guide 1. INSTALLING OR REPLACING THE BATTERY Install 3 Alkaline AA batteries into the battery compartment and re-fit the cover before use. IMPORTANT—before removing the battery compartment cover, ensure the base unit is disconnected from the telephone line. Connection and conditions for use You can connect your SC3123, to public networks in the United Kingdom or to an approved PBX using DTMF signaling. Each item of telephone equipment (phones, fax machines, etc.
SC3123 User Guide year value would flash, use the UP/DOWN key to select value. Press the SET key to enter into next item. AREA CODE LCD display SET 2 CODE, press the SET key to confirm. LCD will display CODE, press the SET key to enter this mode. Use the UP/DOWN key to select value. Press the SET key to enter into next item. Area Code can be used to filter the number for incoming calls. E.g. Area code = 75 when there’s incoming call with 75 6554556, it will be displayed as 655 4556 only.
SC3123 User Guide 4. FUNCTION KEY OPERATION UP and DOWN key In any mode, press the UP/DOWN key to check all the incoming numbers. If there is no incoming call, LCD will display END. The unit can receive up to 16-digit number. OUT key In any mode, check outgoing numbers by pressing the OUT key. Use the UP/DOWN key to select the outgoing number. Press the REDIAL key to dial the selected number.
SC3123 User Guide microphone and listen from the speakerphone without lifting the handset. While off-hook, press the HF key and put down the handset to go into handsfree mode. 5. ADDITIONAL NOTES INCOMING CALL LCD INDICATOR When there is incoming call, the unit will be automatically display the caller number, date and time, and also display its serial number.
SC3123 User Guide DECLARATION OF CONFORMITY The telephone complies with the essential protective requirements and objectives of: • EC R& TTE Directive 1999/5/EC • EC Low Voltage Directive 73/23/EEC • EC EMC Directive 89/336/EEC And conforms to the following relevant harmonized standards: • EMC: EN55022, EN55024 • Safety: EN 60950 Created on 28th October 2005. SC3123 Caller ID Phone. Please visit us at www.shirocorp.com.