Integration Manual

 Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
 Consult the dealer or an experienced radio/TV technician for help.
Operation is subjected to the following two conditions: (1) This device may no cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation. Note: Modification to this product will void the user’s authority to operate
this equipment.
Note: Modification to this product will void the users’ authority to operate this equipment.
5.2 FCC Important Notes:
5.2.1 FCC Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. This equipment complies with Part 15 of the FCC Rules. Operation is subject the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
The devices must be installed and used in strict accordance with the manufacturer’s instructions as
described in this document.
Caution!
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modification could void the user authority to operate
the equipment.
5.2.2 Co-location Warning:
This device and its antenna(s) must not be co-located or operating in conjunction with any other
transmitter antenna.
5.2.3 Integration instructions
This device is intended only for integrators under the following conditions:
(1) The antenna must be installed such that 25 cm is maintained between the antenna and
users,
(2) The transmitter module may not be co-located with any other transmitter or antenna.
(3) The SHNSM was verified in the conformity testing. Radiated transmit power must be equal to
or lower than that specified in the FCC/IC Grant of Equipment Authorization for FCC ID:
2AQMMSHNSM01 and IC: 24124-SHNSM01. A separate approval is required for all other antenna
type, or higher gain antenna.
As long as the above conditions are met, further transmitter testing will not be required. However, the
integrator is still responsible for testing their end-product for any additional compliance requirements
with this module installed (for example, digital device emission, PC peripheral requirements, etc.)