Integration Manual

In the event that these conditions cannot be met (for example certain laptop configuration or co-
location with another transmitter), then the FCC authorization for this module in combination with the
host equipment is no longer considered valid and the FCC ID of the module cannot be used on the final
product. In these and circumstance, the OEM integrator will be responsible for re-evaluating. The end
product (including the transmitter) and obtaining a separate FCC authorization.
Caution!
The integrator is still responsible for verifying compliance with FCC Part 15, subpart B limits
for unintentional radiators through an accredited test facility.
5.3 Industry Canada (IC) Statement:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
RF exposure warning: The equipment complies with RF exposure limits set forth for an uncontrolled
environment. The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter. The device should be installed and operated with a
minimum distance of 20cm between the radiator and your body.
Avertissement d'exposition RF: L'équipement est conforme aux limites d'exposition aux RF établies pour
un incontrôlés environnement. L'antenne (s) utilisée pour ce transmetteur ne doit pas être co-localisés
ou onctionner en conjonction avec toute autre antenne ou transmetteur. L'appareil doit être installé et
utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.
6 Module Marking
The following text shall appear on the SHNSM:
7 Final Product Marking and Documentation
The final product shall be compliant with applicable FCC, IC and R&TTE regulations and directives and
marked for use in both North American and Europe as follows:
7.1 North America
The SHNSM complies with Part 15 of the FCC rules and regulations. Compliance with the labeling
requirements, FCC notices and antenna usage guidelines is required. To fulfill FCC Certification, the final
product must comply with the following regulations:
Model SHNSM01
Shooter’s Touch, LLC
IC: 24124-SHNSM01
FCC ID: 2AQMMSHNSM01