Integration Manual

1. The required label is placed on the outside of the final product.
2. Modules may only be used with antennas that have been tested and approved for use with the
modules. Only the antenna currently integrated into the SHNSM circuit board may be used.
The following statement must be printed on the end-use device or on the device’s user manual in a
conspicuous location.
This device complies with Industry Canada’s license-exempt RSSs and part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Change or modifications that are not expressly approved by the manufacturer could void the
user’s authority to operate the equipment.
Cet appareil est conforme aux normes d’exemption de licence RSS d’Industrie Canada. Son
utilisation est soumise aux deux conditions suivantes: 1. Cet appareil ne doit pas provoquer
d’interférences, et 2. Cet appareil doit supporter toute interférence,y compris celles pouvant
provoquer un fonctionnement non souhaité de l’appareil.
The following has to be put on an exterior label of the end device if the device is too small for the above
text:
Contains FCC ID: 2AQMMSHNSM01
Contains IC: 24124-SHNSM01
If the device is sufficiently large, both the above identifiers and the text above will appear on the outside
of the device.
The following Caution statement must be included in product manuals to alert users of FCC RF exposure
compliance:
Other information related to the final product
IMPORTANT: The final product to comply with unintentional radiators (FCC section 15.107 &
15.109) before declaring compliance of the final product to Part 15 of the FCC Rules.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
CAUTION! To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation distance of 25
cm or more should be maintained between the antenna of this device and persons during device operation. To
ensure compliance, operations at closer than this distance are not recommended. The antenna used for this
transmitter must not be co-located in conjunction with any other antenna or transmitter.