Integration Manual

may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
7.2 Europe
The final product must be in compliance with articles 3.1a and 3.1b of the R&TTE Directive. A Declaration
of Conformity must be issued for each of these standards and kept on file as described in the R&TTE
Directive.
Furthermore, the manufacturer must maintain a copy of the product user manual documentation and
ensure the final product does not exceed the specified power ratings, antenna specifications, and/or
installation requirements as specified in the user guide.
The “CE” marking must be affixed to a visible location on the product. The following figure
shows CE labeling requirements.
The CE mark shall consist of the initials “CE” taking the following form:
 If the CE marking is reduced or enlarged, the proportions given in the above
graduated drawing must be respected.
 The CE marking must have a height of at least 5 mm except where this is not
possible on account of the nature of the apparatus.
 The CE marking must be affixed visibly, legibly, and indelibly.
7.3 Other Approvals
A separate approval of the device into which the module is incorporated is only required when it cannot
be insured that the conditions on the module grant will be met. The integrator must satisfy all relevant
FCC, IC and CE Radio regulations which apply to the finished product.