User Manual

-13-
Model W1666/W1685 (For Machines Mfd. Since 2/15)
SETUP
Assembly
Select an assembly area that is free from clutter and well
lighted.
Tools Needed Qty
Phillips Screwdriver #2 .........................................1
Wrench or Socket 10mm .......................................1
Wrench or Socket 13mm .......................................2
To assemble the dust collector, do these steps:
1. Install four swivel casters to base plate with (16)
M6-1 x 10 Phillips head screws, (16) 6mm flat
washers, and (16) M6-1 hex nuts, as shown in
Figure 4.
Figure 4. Swivel caster attached to base
plate.
x 16
2. With assistance from another person, turn impeller/
motor assembly upside down and attach motor
mount as shown in Figure 5, with (4) M8-1.25 x 25
hex bolts, (8) 8mm flat washers, and (4) M8-1.25 hex
nuts.
Note: Finger tighten these fasteners for now so that
mount can be adjusted in a later step.
3. With assistance from another person, turn impeller/
motor assembly right side up and position it over
attachment holes on base plate (see Figure 6).
Figure 6. Location of impeller/motor
assembly attachment holes.
Impeller/Motor Assembly
Attachment Holes
Figure 5. Motor mount attached to motor.
x 4
Motor
Mount