Use and Care Manual

-10-
W1812 Owner's Manual (Mfd. Since 02/11)
SETUP
This machine has been carefully packaged for safe
transportation. If you notice the machine has been
damaged during shipping, please contact your authorized
Shop Fox dealer immediately.
Unpacking
SETUP
The following is a description of the main components
shipped with the Model W1812. Lay the components out
to inventory them.
Note: If you can't find an item on this list, check the
mounting location on the machine or examine the
packaging materials carefully. Occasionally we pre-install
certain components for safer shipping.
Box Inventory (see Figure 2) Qty
A. Dust Hood ...................................................1
B. Planer/Moulder Head/Table Assembly .................1
C. Link Belt ....................................................1
D. Stand ........................................................1
E. Belt Guard ..................................................1
F. Guide Rail Set ..............................................1
G. Pedestal Control Panel ...................................1
H. Handwheel w/Knob .......................................1
I. Steel Conduit ...............................................1
J. Hardware Bag ..............................................1
— Hex Bolts
5
⁄16"-18 x
3
⁄4" (Planer/Moulder Head) ...4
— Flat Washers
5
⁄16" (Planer/Moulder Head) ..........4
— Hex Bolts
5
⁄16"-18 x 1" (Pedestal Control Panel) ...3
— Flat Washers
5
⁄16" (Pedestal Control Panel) ........3
— Flange Screws
5
⁄16"-18 x
3
⁄8" (Steel Conduit) .......2
— Flange Screws #10-24 x
1
⁄2" (Dust Port Support) ..3
— Hex Bolts
5
⁄16"-18 x
3
⁄4" (Belt Guard) ................2
— Flat Washers
5
⁄16" (Drive Belt guard) ................4
— Hex Nuts
5
⁄16"-18 (Drive Belt guard) .................2
— Lock Levers
1
⁄4"-20 x
3
⁄8" (Guide Rail) ...............4
— T-Slot Nuts
1
⁄4"-20 (Guide Rail) .......................4
— Feet (Stand) .............................................4
— Hex Nuts
3
⁄8" x 16 (Feet) ..............................8
— Hex Bolts
3
⁄8" x 16 x 1
1
⁄4" (Feet) .....................4
— Hex Wrenches
3
⁄32", 4, 5mm ......................1 Ea
— Open-End Wrench 12/14mm ..........................1
— Depth Stop Hex Bolt
5
⁄16"-18 x 1" (Depth Stop) ....1
— Hex Nut
5
⁄16"-18 (Depth Stop) .........................1
Inventory
Keep machine disconnected from
power until instructed otherwise.
Figure 2. Inventory.
B
D
C
A
E
F
H
I
G
J