Use and Care Manual

-12-
W1812 Owner's Manual (Mfd. Since 02/11)
SETUP
The Model W1812 can be moved short distances if two
people lift the ends of the cast iron extension wings
and walk the machine to the new location. For ease of
mobility, the machine can be placed on a Shop Fox Model
D2057A Heavy Duty Mobile Base.
For long distance moving, we recommend using a forklift
or other mechanical lifting or moving device.
Lifting & Moving
Figure 4. Lifting location.
Figure 5. Typical fasteners for mounting to
concrete floors.
Lag Screw and Anchor
Anchor Stud
Before beginning assembly, review the general mounting
options below, while keeping in mind your current and
future machine operation and storage needs. We generally
recommend that most machinery be fastened to the floor
to dampen vibration and provide maximum stability.
However, since floor materials vary, mounting hardware
is not included. Some machinery may find its way into
industrial shops or specialized settings where unique
mounting fasteners and electrical grounding requirements
apply. Make sure to follow all necessary codes and
regulations when installing this machine.
Fastening to Floors
If you choose to physically fasten the machine to the
floor, do not install the included rubber feet. With the
Model W1812, the anchor studs or lag screws shown
in Figure 5 will pass through the four
3
8" diameter
reinforced holes (see Figure 6) that are for the rubber
feet.
Anchor studs are stronger and more permanent
alternatives to lag screws and anchors; however, anchor
studs will stick out of the floor, which may cause a
tripping hazard later if you decide to move your machine.
NEVER use air tools or excessively tighten the fasteners to
level or eliminate the machine from rocking on an uneven
floor. Doing so can bend or twist machine components
and damage the fasteners. Instead add shims between
the machine base and the floor to achieve stability and
alignment before tightening the fasteners by hand.
Mounting Options
Figure 6. Foot installation location.
3
8" Diameter
Reinforced
Mounting
Hole
Machine Feet
If you install the rubber feet included with the W1812,
independent foot adjustment for stability will be possible.
The rubber portions of the feet will also help dampen
machine vibration.