Use and Care Manual

-14-
W1812 Owner's Manual (Mfd. Since 02/11)
SETUP
3. Position the stand upright, adjust the feet so the
stand sits level on the floor, then tighten the lock
nuts to lock the feet in place.
4. Remove the shipping brace shown in Figure 10,
reinstall fasteners in the brace, and save it for
possible later use.
Figure 10. Shipping brace.
Brace
Mounting
Bolts
Shipping
Brace
Figure 11. Placing planer/moulder on stand.
5. With the help of an assistant, lift the planer/moulder
head/table assembly and position it onto the stand,
as shown in Figure 11.
6. Remove the rear panel, then secure the head/table
to the stand with four
5
⁄16"-18 x
3
⁄4" hex bolts and
5
⁄16" flat washers.
7. Place the belt onto the cutterhead pulley with the
belt direction arrow pointing the direction of pulley
rotation. When installed correctly, the internal belt
tangs should be facing against the pulley rotation.
8. Keeping your fingers clear of pinch points, lift the
motor and roll the belt onto the motor pulley as
shown in Figure 12.
9. Attach the belt guard to the stand (see Figure
13) with two
5
⁄16"-18 x
3
⁄4" hex bolts, four
5
⁄16" flat
washers, and two
5
⁄16"-18 hex nuts.
10. Slide the handwheel hub over the shaft (see Figure
13) and tighten the set screw with a 5mm hex wrench.
Figure 13. Belt guard and handwheel instal-
lead.
Belt
Guard
Figure 12. Motor pulley belt installation.
Internal
Belt Tang
Pulley Rotation
Direction