Use and Care Manual

-15-
W1812 Owner's Manual (Mfd. Since 02/11)
SETUP
Figure 14. Control panel support
installation.
11. Feed the control panel wiring harnesses through the
hole in the stand, and secure the pedestal control
panel to the stand, as shown in Figure 14, using
three
5
⁄16"-18 x 1" hex bolts and
5
⁄16" flat washers.
12. Plug the harnesses into their respective sockets just
below the pedestal control panel.
Note: A
5
⁄16"-18 x
3
⁄8" Phillips head screw is pre-
installed in the headstock to keep the moulding
knives clear of the table surface when the headstock
is at its lowest position. To replace the screw with
the included
5
⁄16"-18 x 1" depth stop bolt and hex
nut, simply remove the screw, thread the bolt with
the nut into the hole, then tighten the nut against
the headstock at the location shown in Figure 14.
The minimum workpiece thickness is
1
⁄4" with the
Phillips head screw and
1
⁄2" with the depth stop bolt.
13. Insert the feed motor wiring harness through the
conduit and loom clamps, then plug it into the motor.
14. Fasten the conduit mounting bracket (see Figure
15) to the headstock with two
5
⁄16"-18 x
3
⁄8" flange
screws.
15. Install two T-nuts in each table slot (see Figure 16).
16. Position the inner and outer guide rails so the
elongated T-nut slots (see Figure 16) are positioned
on the infeed table.
17. Insert the lock levers through the guide rails, then
thread them into the T-nuts.
18. Snug the levers in place.
Figure 15. Conduit installation.
Figure 16. Rail installation.
Slot
Inner
and
Outer
Rails
Wiring
Harness
and
Loom
Clamps
Conduit
Mounting
Bracket
Control
Panel
Support
Mounting
Location
Depth Stop