Use and Care Manual

-22-
W1812 Owner's Manual (Mfd. Since 02/11)
OPERATIONS
—If a certain moulding knife profile does not allow
you to adjust the outfeed roller down far enough
for proper roller traction, the eccentric stop must
be repositioned to the lower hole. To do this,
remove the lock nut (see Figure 30), reposition
the eccentric stop in the lower hole (see Figure
31), and finger tighten the lock nut. Next, rotate
the eccentric stop to lower or raise the roller, and
retighten the lock nut.
Figure 30. Lower hole for alternate stop
location.
Figure 31. Removing eccentric stop.
Figure 32. Feed roller spring tension nuts.
3. Completely loosen the four spring tensioner nuts (see
Figure 32), and unthread the tensioner assemblies
until they are not touching the springs.
4. Thread the tensioners back into the housings until
you feel the tensioner just contact the springs.
5. Rotate each tensioner approximately two full turns to
preload the springs, then tighten the nuts.
6. Reinstall the chip deflector.
Eccentric Stop
Lock Nut
Lower
Hole