Use and Care Manual

-27-
W1812 Owner's Manual (Mfd. Since 02/11)
OPERATIONS
Crown Moulding Support
When cutting crown moulding (see Figure 39), make a
wooden V-track that can be clamped to the table. The
V-track must support at least 50% of the workpiece height
on both sides.
Do not use the guide rails that came with your machine
for crown moulding support. If you do, the workpiece can
dislodge and be ejected from the machine, causing severe
injury or damage.
Figure 39. Crown moulding track.
Knife Positioning
When cutting harder woods, some moulding knife profiles
are prone to vibration that leave chatter marks on the
workpiece. To counteract this problem you can stabilize
the cut by installing the moulding knives closer to column
for the best support (see Figure 40).
Moulding knives have many different profiles. Before
starting the machine, always verify that the mould-
ing knives do not contact any part of the workpiece
guide rails, feed roller swing arm, or the table sur-
face. Failure to verify knife clearance may result in
severe injury and machine damage!
CORRECT
INCORRECT
Figure 40. Knife positioning.
CORRECT
INCORRECT